Re:CodeSourcery, DriverLib and first steps

Thank you ravaz for your patience!

I'm using the EK-LM3S6965 board and the following examples: hello world, blinky, uart echo.

I admit I was wrong when I said the -g option is not included. Actually it is, but it is under a ifdef:

ifdef DEBUG
CFLAGS+=-g -D DEBUG
endif

How to set the environment variable DEBUG? Which value should it have? I tried to set to '1' in Eclipse under C/C++ Build -> Build variable and C/C++ Build -> Environment, but I'm not sure I did the right thing.

Same thing applies if I create a new "make target" and pass the "all DEBUG=1" parameter to make command.

Anyway, the debugger (when working) tells me "No symbol table is loaded. Use the "file" command." And no source file is shown in debug perspective.

I don't know why only one time I was able to debug. Perhaps I did the right thing without know what I was doing :(

Thanks again
Marco

Post edited by: femtotech, at: 2008/07/08 00:34